I have programmed irrigation, how come the system does not start? There is a flashing LED on the screen of my control unit, what does it mean? How long does it take the Turbine to recharge the battery of my Pure Vision smart controller? You will find the answer to these and many other frequently asked questions in the section below.
TAP TIMERS
Close the water tap and perform a manual start of one minute per zone. At the end of the manual cycle, open the tap again.
The last figure on the screen indicates the time left before the following irrigation. It can't be changed because it is calculated by the controller.
Press the AUTO/OFF button for 3" and using the '+' button select OFF
Not all controllers are compatible with the rain sensor. Compatible models are: AMICO D AMICO VISION and it is possible to connect the Acqua Vision rain sensor
Feb/23 is a static screen icon and does not affect the programming.
The flashing battery icon means the battery is low and should be replaced.
We recommend replacing the batteries at the beginning of each irrigation season.
ZERO PRESSURE
The control unit can open and close the internal ball valve even with pressure values equal to 0.
The control unit starts after the set frequency period.
The flashing LED indicates that the battery of the control unit is charged.
No, this is not possible. With Zero Pressure, it is possible to set the duration and the frequency of irrigation.
PAL PRO
Yes, the control unit is compatible with normally closed 2-wire sensors. Just connect the two wires of the rain sensor with the red wire of the control unit.
Press the OFF key for 3" and press the + key to confirm OFF
Follow this procedure: close the water supply; remove the batteries for 30 seconds; insert the batteries again and wait 30 seconds; reopen the water supply and check that the system is not running.
The last figure on the screen indicates the time left before the following irrigation. It can't be changed because it is calculated by the controller.
Press the OFF key for 3" and press the + key to confirm OFF
Press the OFF key for 3" and press the + key to confirm OFF
C-DIAL & I-DIAL
Controllers programs identify an area or group of solenoid valves. Zones identify a specific solenoid valve.
Irrigation controller programming is based on irrigation cycles distributed over irrigation programs, which means that it is not necessary to set the start time for all zones. It is sufficient to set the start time of the irrigation cycle (program start time) and the irrigation times of the zones. The controller will then open and close the solenoid valves in sequence.
The days of the week were probably not enabled during programming. Check that the days of the week in the frequency menu are enabled (frame around the day). If they are not active simply press the "+" key to enable the flashing day and move between days of the week with the "enter" key.
Check that the two-wire rain sensor is correctly installed and is a normally closed rain sensor (Acqua Click model). If the rain sensor is not present, check that the metal bridge in the terminal compartment at "SENS" is present. In the case of an I-DIAL OUTDOOR control unit, check that the 220V mains connection has been made correctly (this operation requires a qualified electrician) and that an external 220/24 VAC transformer has not been installed.
It's not possible to activate the rain sensor per zone with C-Dial. It's possible to activate the rain sensor per zone from the EXTRA functions with I-Dial.
It's not possible to activate the rain sensor per zone with C-Dial. It's possible to activate the rain sensor per zone from the EXTRA functions with I-Dial.
Check whether 2 start times or 2 programmes are active
NoAC indicates that the circuit board is not receiving 24VAC. This situation can occur when the fuse is blown or the power supply is blown.
Contact us
to find out more.