AMICO PRO, developed based on the successful 3 Easy Steps programming method. This control unit powered by 2 fully sealed 1.5A batteries can be installed directly in the solenoid valve box. The kit comes with 9 Vdc RN 150 solenoid valve.
Power supply: 2 alkaline batteries 1.5 volts (AA) not included
Rain sensor input
One look display
Removable control unit
Backlit screen
Closing lid
Low battery signal
Maximum number of zones: 1
Minimum pressure: 1 bar
Maximum pressure: 12 bar
Models available: 1 zone
Standard Programming
Programming mode: Traditional
Number of programs: 2
Start times per program: 1
Maximum number of starts per day: 8
Minimum watering time per zone: 1 min
Maximum watering time per zone: 240 min
Irrigation frequency: from every 6 hours to every 15 days
Manual start: By zone
OFF function: Single zone
OFF function: Single programme
9 Vdc solenoid
Battery-operated controllers control 9Vdc latching solenoids. The control unit will send an electrical signal at the start of irrigation to open the solenoid valve and a signal at the end of irrigation to close the solenoid valve.
Sensor input
The controller is equipped with a sensor input for the connection of the rain sensor, 2 wired normally closed. Installation of the rain sensor prevents irrigation during rain events thus saving water.
3 Easy Steps
The special three-step programming feature allows for easy and intuitive programming in less than 60 seconds. The programming logic is based on answering three simple questions: what time of day to water, for how long, and how often.
One Look Display
The 3" backlit display shows you the full irrigation schedule at a glance. It is no longer necessary to navigate through various programming menus to see the irrigation schedule.
Detachable
The removable electronic unit allows for easy programming, battery replacement, and quick solenoid valve maintenance.
Code
Description
Barcode
Sales channel
200.4064560
Control Unit Kit IP68 PAL PRO 1 Zone + E.V. 150 1 "M/UN
8058054004149
200.4064595
Control Unit Kit IP68 PAL PRO 1 Zone + E.V. 150 1 "M/M
8058054010508
200.4064590
Control Unit Kit IP68 PAL PRO 1 Zone + E.V. 150 1 "F
Yes, the control unit is compatible with normally closed 2-wire sensors. Simply connect the two wires of the rain sensor with the red wire of the control unit.
Follow this procedure: close the water supply; remove the batteries for 30 seconds; insert the batteries again and wait 30 seconds; reopen the water supply and check that the system is not running.